Fluoro-Plastics, Inc.  Fluoro-Plastics, Inc. 1-800-262-1910
customerservice@Fluoro-Plastics.com
usa-flag Fluoro-Plastics is a US based manufacturer of Teflon and PTFE products
PTFE Sheet PTFE Plate PTFE Rod PTFE Extruded Tube PTFE Thin Film Reinforced PTFE Bondable PTFE PTFE Guide Rails, Rectangular Bar & Wear Strips PTFE Custom Profiles PTFE Machined Parts Modified PTFE PTFE Gaskets Glass-Filled PTFE Gaskets PTFE Washers PTFE Molded Cylinders PTFE Teflon Square Bar

PTFE and Teflon® Specifications:

PTFE Sheet and Film.....................ASTM D 3294 (and MIL-P22241). Describes the properties and characteristics parameters for PTFE molded sheets (thicker than .250 inches).

PTFE Rod.....................................ASTM 1710 (and MIL-P 19468). Describes the properties and characteristics parameters for different grades of PTFE extruded and molded rod and for heavy-walled tubing.

PTFE Molded Sheet or Shapes.......ASTM D 3294. Describes the properties and characteristics parameters for molded PTFE shapes and molded PTFE sheets.

PTFE Skived Tape.........................ASTM D 3308. Describes the properties and characteristics parameters for skived tape (.250 inches and thinner)

Filled Compounds made
With PTFE
…………………………….ASTM D 4745. Describes the properties and characteristics parameters for filled molding compounds made with PTFE. The specification provides standards for bulk density, tensile strength and elongation of PTFE filled with different percentages of glass fiber, glass fiber and Molybdenum Disulfide, graphite, carbon and graphite, bronze, bronze and Molybdenum Disulfide and stainless steel.

PTFE Tubing………………………....ASTM D 1710. The tubing is intended for electrical, mechanical, chemical and medical applications manufactured from extrusion resins made from PTFE resins.

Molding and Machining Tolerances
for PTFE resin parts
…...................ASTM 3297. This specification defines tolerances applicable to parts molded and free sintered from PTFE resins and to machined parts produced from basic shapes of compression molded or ram extruded resins. The thermal expansion of PTFE parts between 64F and 70F is non-uniform due to a critical transition zone characteristic of PTFE resins.

 
Teflon® is a registered trademark of The Chemours Company FC LLC used under license by Fluoro-Plastics, Inc.
 
Toll Free: 800-262-1910 • Local PA: 215-425-5500 • Fax: 215-425-5521• customerservice@Fluoro-Plastics.com
 
Copyright © 2018 Fluoro-Plastics � All Rights Reserved